We all dream of having immaculate wheels and anything less than perfect is a source of dissatisfaction for many, particularly when buying or selling a second-hand car.
So it is important to pay attention to the details and keep the condition of your alloy wheels spotless to maximise its appeal. Scuffing or scraping your alloy wheels can ruin the look of your car. Thankfully repairing is not as costly as you may think – replacing your alloys is not the only option. If your alloy wheels are no longer in pristine condition, a wheel refurbishment can help to restore the appearance of your wheels, making appear as good as new!
Wheel refurbishment is a thorough step-by-step process, whereby the attention to detail is key to its success. Diamond cutting service involves removing old paint coatings, repairing damage and corrosion and apply a completely new finish. Giving it an exceptional finish and which is extremely durable.
Powder coating is the refurbishment of the whole wheel. This process is normally a full blast to remove blemishes and corrosion, each wheel inspected for damage and repaired of kerb rash or scratches along the way if needs be. The wheel then goes through the powder coating application, this process is as follows: the wheels are put in a pre-heated industrial oven to de-gas the alloy, then the powder coat primer is applied. Once the rims have cooled down, the final clear coat is applied, and the wheels returned to the oven for an additional 30 minutes to set. After which final inspection is conducted to ensure the quality or the paint is second to none.
Refurbishment of a diamond cut wheel which is the same as the powder coated wheel refurbishment, but with the addition of a diamond cutting wheel repair machine process, which removes a thin layer of the wheel face to achieve the diamond cut wheel finish.
Corrosion in diamond cut wheels is quite common, applying lacquer to a polished surface simply defies gravity it is very difficult to achieve a long-lasting finish when applying lacquer to a shiny surface, small stone chips allow water in behind the lacquer and in time causes the lacquer to deteriorate and appear cloudy. Diamond cutting is a very precise process and takes longer to reproduce than a powder coat refurbishment.
Here is a brief breakdown of the Diamond Cut process:
1. Remove the tyres using professional equipment.
2. Mark the tyres and wheels with matching ID numbers to avoid mix-ups.
3. Use a special jet machine to clean your alloy wheels from dirt and grit.
4. De-grease the surface.
5. Place the wheel into the lathe for high-precision cutting focusing on damaged spots.
6. Move the wheel into the pressure-controlled oven to remove any air out of the alloy.
7. Apply a layer of lacquer to protect your wheels from wear and tear.
8. Let your alloys cool for about 20-30 minutes.
9. Carefully inspect the surface to make sure the finish is even and matches high standards.
10. Refit your tyres, check the pressure, and balance the wheels.
With our alloy wheel repair machine we will provide you with the highest quality finish and the quickest turnaround time.
